INSTRUCTIONS FOR USE
DA 170, DA 130
UM_EN_DA170_DA130_2018-09_ver2.6
22
/
37
8.6.2 Programming of Sit-in (Entry/Exit) position
Move the chair to the desired operating position using these keys:
.
Power off the chair, wait for approx. 10 seconds, and then press
key.
Turn on the chair, wait for approx. 15 seconds, and release the
key.
The new Entry-Exit position setting is now programmed into memory.
8.6.3 Programming of Rinsing position
Chair position must be programmed under the button
MOVE DOWN
using this combination:
+
+
In case when somebody changes the position under the button MOVE DOWN, it will cause that Rinsing
position will be changed too.
8.6.4 Choosing the desired pre-set position
First press
key then press one of the following four keys
within the next 5 seconds to move
the chair to the desired pre-set position.
Double-press the
key to recall the most recent position (LAST) of the chair.
8.6.5 Toggling between programmable sets P1/P2
Use the
key to toggle between two separate sets of programmable settings (P1 and P2) for each user.
To switch from P1 to P2 and vice versa, press and hold the
key for more than five seconds.
The acoustic signal indicates that the set has been switched: one beep indicates the P1 mode, and two beeps indicate
P2 mode.
The user settings remain unchanged even after the chair has been turned off.
Acoustic signal (one or two beeps) indicates the current programmable sets the next time the chair is turned on.
Note
Power supply shortage may cause a detuning of the previously programmed chair position settings. Fixing the
problem: move the chair from its maximum to its minimum height (or vice versa) using the two actuating
mechanisms: pre-programmed positions will restore automatically. It is also advised to do so every time before
reprogramming the existing chair positions.
