Diono Radian R120, Инструкции по эксплуатации

Страница: 48 / 64

F
o
r
w
ar
d-
Faci
ng
I
n
s
tal
la
ti
on
48
Forward-facing Lap Belt Installation (cont.)
If available, route the Top
Tether strap to the appropriate
anchor and connect. Do not
tighten until car seat is
installed ( See pages 49 for Top
Tether installation
instructions).
Slide the seat belt through
the forward-facing belt path
behind the fabric and buckle
it. Be sure belt is not twisted.
Put seat belt in locking mode,
if necessary.
Push down on the bottom of
the car seat while pulling all
the slack out of the belt. It is
best to do this close to the
buckle. Be sure belt is locked
and the car seat does NOT
move more than 1 inch
side-to-side, front-to-back at
the belt path.
To check for a tight fi t, grab at
label that states “forward-
facing belt path” with one
hand and give it a moderate
tug. It should move less than 1
inch side-to-side, back-to-
front.
Remove slack from Top Tether
strap if an appropriate anchor
is available ( See page 49 for
Top Tether installation).
❒
See final checklist on page 52
3.
4.
5.
6.
2.