Dionex ASE 100, Руководство оператора

Страница: 85 / 150

5 • Service
Doc. 031842-01 5/02
5-15
4. Turn on the ASE 100 main power switch.
5. Reconnect the gas source at the ASE 100 rear panel and turn on the
gas supply.
5.6 Replacing the Relief Valve
1. Turn off the ASE 100 main power switch.
2. Unscrew the waste bottle from the bottle cap and set the bottle aside.
3. Toggle the needle switch to the UP position. If a collection bottle is installed,
remove the bottle from the bottle holder and set it aside.
4. Turn off the gas supply. Disconnect the gas source at the ASE 100 rear panel.
5. Remove the lower trim panel of the ASE 100:
a. Stand directly in front of the ASE 100, with both hands facing
palm upwards.
b. Hook the first two fingers of each hand under the top edges of the
bottle holders, near the
WASTE
and
COLLECTION
labels (see
Figure 5-3).
c. Brace your thumbs against the bottom of the cell door and the
control panel. Pull forward until the top of the trim panel pops off
the ball studs that secure it to the system.
d. Note the small round depressions on the left and right sides of the
trim panel, near the bottom (see Figure 5-4). Place your index
fingers in these depressions and pull forward until the bottom of
the trim panel pops off.
e. Pull the trim panel completely off, exposing the inner front panel,
and set the trim panel aside.