PAGE 1
(314) 205-3033
WWW.DIODEDYNAMICS.COM
2015+ Dodge Challenger
RGBW
TM
LED Board Installation Guide
Thank you for your purchase of this unique product for your Dodge Challenger!
With these modules, you will be able to control the color of your factory-installed
LED “halos” inside the headlight. They are a direct replacement for the factory
LED panels which illuminate these rings.
1. After opening the headlights, remove the factory LED
panels by removing the screws holding the main bezel in
place. Then remove the screws holding each ring and LED
panel underneath to the housing.
2. Remove the main bezel. Unclip the wire connectors
and remove the factory LED panels.
WARRANTY
3 YEAR
See back for further instructions.
What’s Included:
2 LED Boards, 2 drivers, 1 RGBW extension wire, SolidState Relay Harness
Tools Needed:
Torx T10 Screwdriver, Phillips Screwdriver, Socket Head Wrench
NOTE:
The following instructions are intended to be used with a Diode Dynamics RGBW Controller. If you
do not have a Diode Dynamics controller, these LEDs can be powered with any RGB or RGBW controller
that operates with common anode (positive) powered with an external relay or directly to the battery.
3. Place the new Diode Dynamics LED Boards into
position, running the wires behind the bezel and out
of the headlamp, sealing any holes you may create.
PAGE 1
(314) 205-3033
WWW.DIODEDYNAMICS.COM
2015+ Dodge Challenger
RGBW
TM
LED Board Installation Guide
Thank you for your purchase of this unique product for your Dodge Challenger!
With these modules, you will be able to control the color of your factory-installed
LED “halos” inside the headlight. They are a direct replacement for the factory
LED panels which illuminate these rings.
1. After opening the headlights, remove the factory LED
panels by removing the screws holding the main bezel in
place. Then remove the screws holding each ring and LED
panel underneath to the housing.
2. Remove the main bezel. Unclip the wire connectors
and remove the factory LED panels.
WARRANTY
3 YEAR
See back for further instructions.
What’s Included:
2 LED Boards, 2 drivers, 1 RGBW extension wire, SolidState Relay Harness
Tools Needed:
Torx T10 Screwdriver, Phillips Screwdriver, Socket Head Wrench
NOTE:
The following instructions are intended to be used with a Diode Dynamics RGBW Controller. If you
do not have a Diode Dynamics controller, these LEDs can be powered with any RGB or RGBW controller
that operates with common anode (positive) powered with an external relay or directly to the battery.
Please note:
Headlights must be opened before proceeding with installation.
This process can be completed by heating and prying the lens from the housing.
We recommend viewing example videos online to understand the process;
however, professional installation is strongly recommended. Please contact
Diode Dynamics if you need assistance locating an installer.
3. Place the new Diode Dynamics LED Boards into
position, running the wires behind the bezel and out
of the headlamp, sealing any holes you may create.
