Dinolift DINO 280RXT, Руководство по эксплуатации

Страница: 62 / 74

62
Operating instructions • DINO 280RXT
Optional warning signals:
1
Warning for boom lowering movements (option).
• Works while driving boom movements (marked with
1
in the table) from the UCB controls.
• Warning buzzer sounds on ground level to warn pedestrians in the area.
2
Warning for driving (option)
• Works while driving the machine.
• Uses a sound signal, warning beacons or both
8.2. FAULT CODES
The machine has a self diagnostic system that monitors the state of the machine and the
control system.
When a fault code is active, the lights on the display panel buttons flash and a pop up
message will appear on display. Depending on the fault, the diagnostic system can also limit
the operability of movements while a fault code is active.
If a fault code has been triggered for example by a temporary fluctuation in control signal or
system pressure:
• Reset the system by pressing the emergency stop button or switching off the main switch.
• Start the machine normally.
If the fault code does not appear again after re-start, the machine can be operated normally.
For more detailed information about fault codes and their effects, see the maintenance
manual.
To avoid most common fault causes:
• Keep the battery well charged.
• Warm the engine and oils up before operation in cold conditions.
• Do not open the hydraulic reservoir or connections unnecessarily.
• Fix loose bolts and electric connections if you notice them.
• Keep all covers and electric boxes closed at all times. Moisture in the system can cause
contact failures.
• Lubricate the necessary points regularly.
• Follow the maintenance schedule.
• KEEP THE LIFT CLEAN AND PROTECT IT AGAINST MOISTURE.