Dinolift 10196, Руководство по эксплуатации

Страница: 44 / 59

44
Operating instructions • DINO 105TL
6. INSTRUCTIONS FOR FAULT-FINDING
FAULT REMEDY
1. The electric motor does not start from its start button although the selector switch 1
is in the position that enables operation from either the chassis or the platform control
centre
Emergency stop button has jammed in its lowest
position.
Pull up the button and re-start the motor from the
start button.
Fuse F1 has blown. Replace the fuse (10A).
No mains supply (230 VAC) to the selector
switch.
Check the extension cords, possible distribution
boards and fuses.
Fault current safety switch has tripped. Reset the fault current safety switch.
2. No power supply to the lift, although the main switch is on and the selector switch
is in either of the positions, which enable the operation from the chassis control
centre or from the platform control centre
Power supply has not been activated.
Press the start button to activate the power
supply.
3. None of the boom movements is operational, although the electric motor is running
and the selector switch stands in the correct position (operation either from the
chassis control centre or the platform control centre)
Green signal light for the outriggers is not
illuminated.
Make sure that the outriggers are steady
supported on the ground, and the tyres are off the
ground.
4. Outriggers do not move
The boom is not resting on the transport support. Drive the boom onto the transport support.
The selector switch is in the wrong position.
Turn the selector switch to the
correct position.
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
The limit switch on the boom support has not
closed.
Drive the boom onto the transport support.