Dinolift 10196, Руководство по эксплуатации

Страница: 31 / 59

31
5.1.3. Starting up
To access the operating controls, open the cover of LCB centre on the turning device.
1. Switch on the current for the lift
• connect the mains cable to the power supply
• with the electric motor at maximum load, the voltage must be 230 VAC (-10%/ +6%),
the frequency 50 Hz, and rating of the fuse 10A (the length of the connecting cable
has some effect)
2. Turn the selector switch Q1 to position LCB – chassis control centre.
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
3. Start the engine using either of the speed selector switches
5.1.4. Supporting the lift
1. Lower the front outriggers (on the tow-bar side).
2. Lower the outriggers in the rear. (do not damage the tow-bar jockey wheel).
3. Level the chassis using the outriggers in accordance with the level gauge. The air bubble
must be located inside the inner ring.
4. The green signal light in the chassis control centre LCB is illuminated, when all the
outriggers are in the support position and the limit switch circuit of the outriggers is
closed.
Before using the lift, always check that:
• the chassis is in the horizontal position, in accordance with the position indicator
• the wheels are off the ground
• the outriggers are firmly supported on the ground, and the limit switch circuit of the
outriggers is closed (green LED in the chassis control centre is illuminated)
DANGER
WARNING
CAUTION
NOTICE
The operation is prohibited, if the lift is not properly supported and in a horizontal
position.
Observe the effect of ice, possible rain and inclination of the surface on the support
(the support outriggers must not slip on the surface).