Dino-Power DP6388B, Оригинальная инструкция, Страница: 6 / 15

6.
Off spray
Too thick
Start
Pull
stroke trig ger
Release End
trigger stroke
Pressure Relief Procedure
WARNING
Avoid arcing or holding the gun at an angle ,This will result in
an uneven finish.
Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose ,including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for clean up.
1.Lock the gun by turning the gun
trigger lock to the lock position.
2.Turn the unit off by moving the
ON/OFF switch to the OFF position.
3.Turn the pressure control knob
counterclockwise to its OFF position
4.Unlock the gun by turning the gun Trigger lock
trigger lock to the unlocked position in locked position
5.Hold the metal part of the gun firm ly to
the side of a metal container to ground
the gun and avoida build up of static
electricity.
6.Trigger the gun to remove any
pressure that may still be in the hose
7.Lock the gun by turning the gun trigger lock to the locked
position.
8.Move the PRIME/SPRAY valve down to the PRIME
position.
Spraying
Arcing
Gun at angle
Proper lapping(overlap of spray pattern) is essential to an
even finish. Lap each stroke .If you are spraying horizontally,
aimatthebottomedge ofthe preceding stroke,so astolap
the previous pattern by 50%.
WARNING
POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place .Never trigger the gun unless the tip is
in either the spray or the unclog postion ,Always engage
the gun trigger lock before removing ,replacing ,or
cleaning tip.
Spraying Technique
The following techniques ,if followed,will assure professional
painting results.
Hold the gun perpendicular to the surface and always at equal
distance from the surface. Depending on the type of material,
surface ,or desired spray pattern,t he gun should be held ata
distance of 30 to 50 cm (12 to 14 inches)
Move the gun either across or up and down the surface ata
steady rate. Moving the gun at a consistant speed conserves
material and provides even coverage .The correct spraying speed
allows a full ,wet coat of paint to be applied without runs or sags.
Holding the gun closer to the surface deposits more paint on
the surface and produces a narrow spray patern.. Holding
the gun farther from the surface produces a thinner coat and
wide spray pattern .If runs ,sags ,or excessive paint occur,
change to a spray tip with a smaller orifice . If there is an
insufficient amount of paint on the surface or you desire to
spray faster ,a larger orifice tip should be selected.
Maintain uniform spray stroke action ,Spray alternately from left
to right and right to left. Begin movement of the gun before the
t rigger is pulled.
For corners and edges ,split the
center of the spray pattern on the
corner or edge and spray
vertically so that both adjoing
sections receive approximately
even amounts of paint.
When spraying with a shield ,hold it firmly against the surface.
Angle the spray gun slightly away from the shield and toward
the surface This will prevent paint from being forced underneath.
Shrubs next to housed should be tied back and covered witha
canvas cloth .The cloth should be removed as soon as possible.
our gun extensions are extremely helpful in these situations.
Nearby objects such as automobiles ,outdoor furniture,etc.
should be moved or covered whenever in the vicinity ofa
spray job.Be careful of any other surrounding objects that
could be damaged by overspray.
Overlap edges
1st 2st 3st 4st 5st
pass pass pass pass pass