DINGLI S06-E, Руководство оператора с информацией по обслуживанию

Страница: 54 / 77

OPERATOR’S MANUAL
with Maintenance Information
Maintenance
50
B-2
Inspect the Electrical Wiring
DINGLI requires that this procedure be
performed every 250 hours or quarterly,
whichever comes first.
Maintaining electrical wiring in good condition
is essential to safe operation and good
machine performance. Failure to find and
replace burnt, chafed, corroded or pinched
wires could result in unsafe operating
conditions and may cause component
damage.
Electrocution / burn hazard.
Contact with electrically charged circuits could
result in death or serious injury. Remove all
rings, watches and other jewelry.
1 Inspect the underside of the chassis for
damaged or missing ground strap(s).
2 Inspect the following areas for burnt,
chafed, corroded and loose wires:
•
Ground control panel
• Hydraulic power unit module tray
•
Battery pack module tray
• Platform controls
3 Turn the key switch to ground control. Turn
the ground red Emergency Stop button
clockwise to the on position. Pull out the
platform red Emergency Stop button to the
on position.
4 Raise the platform until the distance of the
two sets of scissor at least 0.5m.
5 Lift the safety arm, move it to the center of
the scissor arm and rotate down to a
vertical position.
6 Lower the platform until the safety arm
rests securely on the link. Keep clear of
the safety arm when lowering the platform.
Crushing hazard. Keep
hands clear of the safety arm when lowering
the platform.
7 Inspect the center chassis area and
scissor arms for burnt, chafed and pinched
cables.
8 Inspect the following areas for burnt,
chafed, corroded, pinched and loose
wires:
•
Scissor arms
• ECU to platform controls
•
Power to platform wiring
9 Inspect for a liberal coating of dielectric
grease in the following locations:
• Between the ECU and platform controls
•
All wire harness connectors Level sensor
10 Raise the platform and return the safety
arm to the stowed position.
11 Lower the platform to the stowed position
and turn the machine off.