DINGLI JCPT0307, Руководство оператора с информацией по обслуживанию

Страница: 27 / 73

23
OPERATOR’S MANUAL
with Maintenance Information
Operating Instructions
button light is on, slow drive speed mode is
active. When the button light is off, fast drive
speed mode is active.
Press the drive speed button to select the
desired drive speed.
To determine the slope grade
Measure the slope with a digital inclinometer
OR use the following procedure.
You will need:
Carpenter’s level
Straight piece of wood, at least 1 m long
Tape measure
Lay the piece of wood on the slope.
At the downhill end, lay the level on the top
edge of the piece of wood and lift the end until
the piece of wood is level.
While holding the piece of wood level,
measure the distance from the bottom of the
piece of wood to the ground.
Divide the tape measure distance (rise) by the
length of the piece of wood (run) and multiply
by 100.
Example:
Run = 3.6 m
Rise = 0.3 m
0.3 m ÷ 3.6 m = 0.083 x 100 = 8.3%
If the slope exceeds the maximum slope or
side slope rating, the machine must be
winched or transported up or down the slope.
See Transport and Lifting section.
Operation from Ground with
Controller
Maintain safe distances between operator,
machine and fixed objects.
Be aware of the direction the machine will
travel when using the controller.
Battery Level Indicator
Full Low
Use the LED diagnostic readout to determine
the battery level.
How to use the Safety Arm
1 Raise the platform approximately 1.5 m
from the ground.
2 Rotate the safety arm away from the
machine and let it hang down.
3 Lower the platform until the safety arm
rests securely on the link. Keep clear of
the safety arm when lowering the platform.
Don’t engage the safety arm
unless unload the platform.
How to use the Swivel Wheel
lock (If applicable)
1. Adjust the swivel wheel to the forward
direction position.
2. Pull out the lock pin and rotate 90
°
clockwise, then release the lock pin.