Button (+) increases the value
displayed. Pressed together
with button (-) allows
modifying the brightness
Six LEDs indicating the selected
feature
:
TC
=>
Traction Control
EB
=>
Engine Braking
QS
=>
Electronic Quick Shifter
AFR
=>
Air Fuel Ratio
LC
=>
Launch Control
RPM
=>
Revolutions per Minute
Button
MODE
selects
a specific
feature
and
saves
new settings in
Rapid Bike module’s
memory
_
O2 sensor heating
O
O2 sensor operating
OO
O2 sensor operating / Rapid Bike
is modulating
Quick start guide
full version can be downloaded
from
www.rapidbike.com
1.
Update the EVO/RACING module firmware with Rapid Bike software version 2.0.6.8 or further
2.
Fasten the device, using the supplied Velcro, in a position easy to look at and reach (see picture)
3.
Route YOUTUNE wiring harness up to the Rapid Bike module and fasten it to the OEM harness using cable ties
4.
Connect the three connectors of YOUTUNE harness to the Rapid Bike main wiring harness
5.
Turn ignition on. Device must light up all LEDs and the display; then it should set to RPM position showing 0 rpm
PLEASE PAY ATTENTION TO THE FOLLOWING:
- DO NOT TAKE AWAY YOUR ATTENTION FROM DRIVING WHILE OPERATING WITH THIS DEVICE
- USE ONLY WITHIN ENCLOSED RACING TRACKS, NOT INTENDED FOR STREET AND PUBLIC ROADS USE
- YOUTUNE SPECIFIC FUNCTIONS ARE LISTED FOR EACH SINGLE BIKE MODEL ON RAPID BIKE APPLICATION LIST AVAILABLE ON-LINE
RPM:
showing the information listed above; pushing (-) button for 2 seconds it enables a
RPM/Speed
Control
function to maintain engine rpm at constant level, therefore cruising at constant speed.
(*) Bike models equipped with ride-by-wire system
CAN NOT
disable this
RPM/Speed Control
function
by opening at full gas; be sure to use the other two systems as described above
AFR:
Changing target value of auto-adaptive feature in order to modify fuel adjustments performed automatically
by EVO and RACING modules
and obtain a richer (
+
means more gasoline) or leaner (
-
means less gasoline ) fuel mixture.
Default value is 0 (no variations of auto-adaptive feature's target), and it can be modified of +/- 2 points. An additional push after -2 points value stops
auto-adaptive feature from operating and display shows “
OFF
”; keep in mind latest correction values will continue to be applied.
YOUTUNE operates directly on the Air/Ruel Ratio with modifications up to +/- 10 points (1 point = 0,1 AFR)
ONLY
when it is installed one or more My
Tuning Bike unit. An additional push after -9 point value stops this function, while latest correction values continue to be applied.
Button (-)
decreases the
value displayed
and activates
RPM/Speed
control
Alphanumeric display shows the
value of the selected
feature
Ten LEDs on a curved line for
analog representation of specific
values being measure:
blue = low - red = high
RPM
TPS
RPM
AFR
RPM
RPM
Gear TPS
AFR
O2 TPS
+
RPM limiter
̶
2sec.
+
+
+
MODE
̶ 2sec.
Full gas*
+
100rpm
-
100rpm
STOP
RPM
limiter
AFR
MODE
AFR
O2 Target
+
̶
AFR
oo
1
AFR
oo
-1
AFR
oo
2
AFR
oo
-2
+
̶
̶
AFR
oo
OFF
TECHNICAL TERMS
TPS
= Throttle Position Sensor
O2
= Oxygen / Lambda sensor
Ride-by-wire
= Electronic
throttle