11
Operation
5. SELECTOR DIAL
can be turned clockwise
and counter clockwise, and enables the re
-
quired room temperature to be adjusted. The
screen color changes for warmer and cooler
settings, showing deep blue through to bright
red.
To check what setting the heater is currently
using press the selector dial once and the
timer mode will be displayed e.g. ‘
Work
Week’
.
!
NOTE:
The
selector dial
is also used in combi
-
nation with the
menu
button to select and confirm
your settings.
Setting the Date and Time
Your Quantum controller incorporates a real time
clock with a calendar function. The time clock has
a battery back up that will keep the clock running in
the event of a power outage.
To adjust the time or date follow the steps below.
!
NOTE:
The display screen will return to stan
-
dard display after a period of 20 seconds of inactiv
-
ity.
• Press the Menu Button (1).
• Select Date/ Time by pressing the control dial
(2).
• Rotate the dial to select the correct ‘day’ and
press the centre of the dial to select.
• Rotate the dial to select the correct ‘
Day of
the Month
’ and press the centre of the dial
to select. Repeat this operation until date and
time have been sent and the display returns to
the Main Menu.
!
NOTE:
When the heater is initially installed, a
Warning Message may appear. This means the
real time clock has not been initialized. This can be
set by pressing the Menu button and following the
above steps to set the time.
Choosing and Setting a Timer Mode
Your Quantum controller comes pre-programmed
with a set of operating periods. There are four op
-
tions available - three preset (Work Week, Home
All Day and Holiday), and one user setup (Manu
-
al).
The preset options include days and times (out
-
lined below) that are pre-programmed to release
heat based on temperature set points.
The heater is programmed so that the amount of
heat that is stored is adjusted depending on the
time of the year, i.e. in January the heater will be
using the full capacity of the storage capabilities
and in April only a portion will be used. Also the
settings for the months May - August the storage
ability is disabled, so if the controller calls for heat
the supplemental element will provide it and no
heat will be stored.
!
NOTE:
The Work Week, Home all Day and
Manual timer modes will use the comfort tempera
-
ture during the “On” times and a setback tempera
-
ture during the “Off” times.
How to set the setback
temperature can be found under the description of the
“Options” Menu in this document.
1. Work Week
(pre-programmed) - Has the fol
-
lowing preset times, which can be altered if
desired;
Monday – Friday: On 6:00 am until 8:00 am
