7200810000R01
Radiant Heater
KRR Series
Installation Instructions
ImpoRtant InStRuctIonS
please carefully read and save these instructions
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock
and injury to person, including the following:
Read all instructions before using this heater.
1.
A heater has hot and arcing or sparking parts inside. Do
2.
not use it in areas where gasoline, paint or flammable
liquids are used or stored.
This heater is hot when in use. To avoid burns, do not let
3.
bare skin touch hot surfaces. If provided, use handles
when moving this heater. Keep combustible materials
such as: furniture, pillows, bedding, papers, clothes and
curtains away from heater.
To prevent a possible fire, do not block air intakes or
4.
exhaust in any manner. Do not use on soft surfaces like
a bed where openings may become blocked.
Do not insert or allow foreign objects to enter any venti-
5.
lation or exhaust opening as this may cause an electric
shock or fire, or damage the heater.
SaVE tHESE InStRuctIonS
General Information
Local and National electrical codes must be followed and
1.
take precidence over theses instructions.
This heater is for mounting only on a metallic outlet box
2.
that is designed for use with rigid metal conduit.
All right hand support fittings must be tight to ensure con
-
3.
tinuity of electrical ground throughout the chassis.
The heating element and extruded enclosure may at
-
4.
tain operating temperatures on 815° C (1500° F). This
should be taken into consideration when choosing a
mounting location for these heaters.
Best results are obtained if people are irradiated at an
5.
angle rather than directly from above.
Heaters may be wired together to form an electrical net
-
6.
work in single or three phase circuits.
Congratulations on purchasing a small wall heater from
Dimplex North America. Your heater is manufactured using
the highest quality materials and workmanship and will
provide many years of trouble free service.
This heater is designed for permanent installation only,
care should be taken to install according to the following
instructions. All required clearances should be maintained, in
addition all electrical wiring and connections should comply
with local electrical codes.
!
notE:
It is extremely important to read all information
labels. Care must be taken to ensure that the heater is
rated the same voltage as the electrical supply wires.
Failure to do so could result in unsafe heater operation as
well as damage to the unit. If replacing an existing heater,
check the labels of the old heater to ensure the voltage of
the new heater is compatible.
Install a suitable electrical outlet box for mounting the
1.
heater.
Using two 3/4” conduit bushings, secure the right hand
2.
support of the heater to the outlet box. (Figure 1)
Bring in electrical supply and connect to heater supply
3.
leads inside outlet box. Use at least 75 degrees C wire
for electrical connections.
Fasten cover to outlet box.
4.
Adjust heater for the desired angle of radiation using the
5.
following methods: (Figure 1)
a) To rotate heater chassis in the A-A direction; loosen
the locking collar of the EMT fitting shown, rotate the
heater chassis to the desired angle, then retighten
the fitting.
b) Rotation of the heater chassis in the B-B direction
is achieved through a similar process, using the set
screw located in the type “T” condulet.
Figure 1: Dimensions
cm
in
A
46
18
B
9.2
3-5/8
C
9.4
3-11/16
D
6.4
2-1/2
E
5
2
FIGuRE 1
