19
DS5598, DS5603, DS5804
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE THE POWER CORD
1. Remove the stove pipe kit (if equipped).
2. With front door closed, gently place stove door side down on a flat surface.
3. Remove the retaining screws on the
REAR
stove legs with a screwdriver and
remove the rear legs.
4. Remove the rear cover retaining screw located at the lower center of the rear cover.
5. Slide the rear cover down 4 to 6 inches and gently pull the cover up from both the
top and bottom bowing it slightly and remove it from its mounting slot. When the
cover is removed place beside the stove being careful not to damage any of the
wiring.
6. Locate and disconnect the power cord wiring connections noting their original
locations.
7. Remove the heater cover retaining screws located on the bottom of the stove with a
screwdriver.
8. Lower the heater cover off of the bottom of the stove being careful not to damage
any of the wiring.
9. With needle nose pliers grasp the power cord strain relief grommet from inside the
heater cover and push while twisting to remove.
10. Pull the power cord out through the hole in the heater cover.
11. Install the new power cord through the hole in the heater cover and connect all of the
wiring connections in their original locations.
12. Install the power cord retaining grommet on the power cord and insert into the hole
in the heater cover.
13. Reassemble in the reverse order as above.