10
www.dimplex.com
Installation
RISK OF FIRE/ EXPLOSION
• This heater should not be used in potentially explosive atmospheres.
• Do not use in areas where gasoline, paint, or flammable liquids are used or stored.
• Installation minimum clearances specified in this manual must be followed.
• The heater must be installed in accordance with the manufacturer’s installation instructions.
Minimum Clearances
This appliance must only be used in a well ventilated area. The heater should not be installed:
• Where heat ignition can cause damage to gas cylinders/lines.
• Near other combustible materials.
• In open locations subject to harsh weather elements such as rain or snow.
Heater should be installed to allow adequate:
• Clearance around air openings to combustion chamber.
• Clearance from combustible material.
• Provisions for accessibility and clearance for combustion and ventilating air supply.
Figure 3
shows the required clearances around the heater. All dimensions shown are minimum values.
40"
1016 mm
40"
1016 mm
20"
500 mm
40"
1016 mm
12"
300 mm
103"
2610 mm
Figure 3
12" (300 mm) with
accessory DGRSHIELD
(sold separately)
