18
www.dimplex.com
Tools Required:
Phillips-Head Screwdriver
Pliers
1. Follow the instructions for
Preparing Firebox for Service
on page 10.
2. Remove the screws that secure the flame panels (number of screws will vary) (
Figure 17
). Set the flame panels aside,
making note of their original order as they are removed
.
3. Remove the 2 screws on each extremity (4 total) of the flame LED bracket (
Figure 18
).
4. Pinch each rivet using pliers while gently pulling the LED board off to release it (
Figure 19
).
5. Position the new flame LED board, and secure it by gently pressing it onto the rivets. Ensure the IN marking on the
board is oriented toward the right side.
6. Secure the flame LED bracket using the 4 screws previously removed.
7. Reinstall the flame panels in the order opposite of which they were removed, ensuring they remain in the correct
order.
8. Reassemble the firebox.
Flame LED Replacement
Flame Panels (quantity
will vary by model)
Flame LED Bracket
Pinch rivets using pliers
to release LED board
Figure 17
Figure 18
Figure 19
