GETTING FAMILIAR WITH THE GTS-1000 CAPABILITIES
Working area
The GTS-1000 Series features a large working area ideal for testing large samples up
to
10.2 inches (260 mm) wid
e. The versatile T-slots can secure unusual shaped fixtures
or parts in tension. T-nuts and screws may be used to secure other fixturing.
Do not allow fluid to run into the T-slots. Tests with potential for running fluids should
secure The Dillon oversized plate accessory (available separately) to the T-slot work
surface and remove the side T-slot cover plates. Always unplug the stand immediately
if fluid runs into the T-slot and do not reconnect until all fluid is cleared and dried.
WARNING
Do not allow fluid to run into the T-slots. This can
produce an electrocution hazard. Always unplug the
stand immediately if fluid runs into the T-slot and do
not reconnect until all fluid is dried.
The GTS-1000 includes a handy tension base plate for in-line tension
grips as well. To remove or install, remove one cover plate side
screw and loosen the other. Rotate cover 90 degrees. Slide tension
plate with T-nuts loosely attached in or out as desired. Rotate cover
back and retighten screws.
Column
The GTS-1000 Series is a single column stand designed for vertical use. Maximum
crosshead trav
el is 18.7 inches (475 mm).
The GTS offers exceptional working headroom of 22.8 inches (580 mm) with the GTX or
GS force gauge. Over 5 inches (125 mm) of extra headroom reduces travel loss impact
due to fixturing. Extension rods may be required for short samples with low profile
fixturing. In compression, blocks may be used to elevate the sample as needed.
9
