Chapter 3: Configuration
Testing Your Configuration
1.
Load DAHDI drivers into the kernel using the
modprobe
utility. The
appropriate driver for the TE800 Series cards is
wct4xxp
. Users in all
countries except Australia should use the following modprobe
command:
# modprobe wct4xxp
# dahdi_cfg -vv
2.
Run
dahdi_tool
from the command line and see if the span turns
green for each span you have connected.
# dahdi_tool
3.
Execute the following Asterisk command to see if the span came up
successfully.
# asterisk
# asterisk -vvvr
Digium, Inc.
Page 53
Содержание TE800 Series
