Digium TE800 Series, Руководство пользователя

Страница: 45 / 75

Chapter 3: Configuration
Configuring T1/E1 Lines
1.
Begin by opening the system.conf file from the
/etc/dahdi
directory.
2. Specify the two letter country code for your loadzone and defaultzone.
This will preload tone zone data and specify a default tone zone for
your interfaces.
The following is a typical setup for a telco in the US:
loadzone = us
defaultzone = us
3. Configure the SPAN Map.
For each T1/E1 you are using, you will need to define a span. The
SPAN map includes defining the SPAN number, timing, line build out,
framing, and coding. Configuration details for each of these items is
explained in this section.
span => <Number>,<Timing>,<Line Build
Out>,<Framing>,<Coding>[,Yellow]
Number:
This is the span the T1/E1 line is plugged into. Refer to Figure 5 on
page 24 to determine the span.
Digium, Inc. Page 45