D
IGITAL
C
ONTROL
I
NCORPORATED
DigiTrak Falcon F1™ Operator's Manual
51
When the receiver exits Target Steering mode, the remote display automatically returns to the normal
Remote Locating screen and the receiver no longer displays horizontal distance from transmitter to receiver.
Setting the Target Depth
Use the third screen in the Target Steering menu to set the target depth. This screen is similar to the first
screen except that a question mark appears in place of the current target depth value.
1. Hold the trigger briefly to set the target depth value.
1.
Select to set target depth
2. The first digit is underlined. Click to select the next digit, or hold briefly to change the value.
1.
Current selection
2.
Select to confirm setting
3. Upon selection, the value becomes boxed. Click to scroll through numeric values, then hold briefly
to select. Click to select subsequent values and hold briefly to change.
4. When the target depth is set correctly, select the check mark to confirm. A check mark appears
briefly next to the receiver icon and the receiver beeps and returns to the Locate screen with Target
Steering enabled.
If you click past your desired foot value, either click through the maximum value of 99 ft. or wait about five
seconds to exit without saving and try again.
If you click past 11 in. in the inches field, the number in the
ft.
field will automatically increase.
To maintain the most accurate readings on the remote display, never set the target steering depth more than
3 ft. from the current depth.
