DIGITIZE DGM-32/64, Руководство по установке и обслуживанию

Страница: 47 / 59

DGM INSTALLATION AND MAINTENANCE MANUAL
700135-0000 Rev. O 37
4.3.33 FUNCTION 32 (ERASE ALL PINS)
This function will erase all stored PINS that have been programmed if a keypad has
been installed.
To view or change Function 32, press “32”, then press FUNC or, if you are viewing
the previous function, just press FUNC. The second line of the display wi
ll read “32 -
Reset Kypd.” A message will scroll on the first line:
Erase all PIN numbers. Use the READ button to select the keypad
by entering value from 0 to 15, then press the READ button. Enter
"1", then press ENTER to erase all pin numbers. Press CLR/SIL to
clear display or FUNC to view next Function.
Press CLR/SIL to clear the display. Press FUNC to advance to the next function.
4.3.34 FUNCTION 33 (TOGGLE RELAY)
This function allows you to test all relays in the DGM. You can toggle the relay ON
and OFF or OFF and ON depending upon the state of the relay at the point when
you entered this function. The LCD display will show the condition of the relay.
To view or change Function 33, press “33”, then press FUNC or, if you are viewing
the previous function, just
press FUNC. The second line of the display will read “33 -
RLY00 Off.” A message will scroll on the first line:
Toggle relays ON and OFF. Enter relay number, then press READ.
TGGL button will turn relay ON and OFF. Press CLR/SIL to clear
display or FUNC to view next Function.
Press CLR/SIL to clear the display. Press FUNC to advance to the next function.
4.3.35 FUNCTION 34 (SHOW BYPASS)
This function allows the LCD to display ZONE BYPASSED when the LCD scrolls
through its events. The default for this option is disabled.
To view or change Function 34, press “34”, then press FUNC or, if you are viewing
the previ
ous function, just press FUNC. The second line of the display will read “34 -
Show Bypass.” A message will scroll on the first line:
Display Bypass Zones is Disabled. Press the TGGL button to
change. Press CLR/SIL to clear display or FUNC to view next
Function.
Press CLR/SIL to clear the display. Press FUNC to advance to the next function.
4.3.36 FUNCTION 35 (DISPLAY KEYPAD STATUS)
This function will display the keypad and access when the zone has been placed in
access mode.
To view or change Function 35, press “35”, then press FUNC or, if you are viewing
the previous function, just press FUNC. The second line of the display will read “35-
Dsp Kypd Stat.”
A message will scroll on the first line: