DIGITIZE DGM-32/64, Руководство по установке и обслуживанию

Страница: 35 / 59

DGM INSTALLATION AND MAINTENANCE MANUAL
700135-0000 Rev. O 25
To change the Passnumber, enter the new six-digit number on the keypad and
press ENTER. The new Passnumber will display in the scrolling message. Press
CLR/SIL to clear the display. Press FUNC to advance to the next function.
4.3.5 FUNCTION 4 (SETTING TO BEEP ON ALARM)
This function selects whether or not the beeper will sound when an alarm is initiated
on any of the inputs. If Function 4 is off, the beeper will only sound after a
“TAMPER” condition. If Function 4 is on, the beeper will sound any time a zone input
goes into alarm. (The beepercan always be cleared by pressing the CLR/SIL
button.)
Note: This function is automatically downloaded from the SYSTEM 3505 PRISM LX
when the SET button is pressed in the MULTIPLEX ADD/CHANGE/DEL mode or
when SYSTEM 3505 PRISM LX restarted.
To view or change the Beep on Alarm option, press “4”, FUNC or, if you are viewing
the previous f
unction, just press FUNC. The second line of the display will read “4 -
Beep on Alarm.” A message will scroll on the first line:
Press the TGGL button to change. Press CLR/SIL to clear display or
FUNC to view next Function.
To enable/disable Function 4, press TGGL. The display will indicate whether or not
the option is enabled. Press CLR/SIL to clear the display. Press FUNC to advance
to the next function.
4.3.6 FUNCTION 5 (SETTING DATA SYNCHRONIZATION)
Note: This function is automatically downloaded from the SYSTEM 3505
PRISM LX when the SET button is pressed in the MULTIPLEX ADD/CHANGE/DEL
mode or when SYSTEM 3505 PRISM LX restarted.
When the DGM panel is being used with a SYSTEM 3505 PRISM LX with program
revision 5.4.0 or higher, Function 5 should be turned on to activate Data
Synchronization. Data Synchronization improves the way the DGM panels and
SYSTEM 3505 PRISM LX communicate. This option must be activated at the
SYSTEM 3505 PRISM LX for proper communication when DGM panels have this
option activated.
Note: Activating Data Synchronization on an DGM panel may prevent it from
communicating with a SYSTEM 3505 PRISM LX. See the SYSTEM 3505
PRISM LX manual for instructions on how to activate Data
Synchronization in the SYSTEM 3505 PRISM LX.
To view or change Function 5, press “5”, FUNC or, if you are viewing the previous
function,
just press FUNC. The second line of the display will read “5 - Data Sync.” A
message will scroll on the first line:
The Data Sync option is Enabled. Press the TGGL button to change.
For System 3505 Prism Lx rev 5.0.0 & up should be ON. Press
CLR/SIL to clear display or FUNC to view next Function.
To change enable/disable Function 5, press TGGL. The display will indicate whether
or not the option is enabled. Press CLR/SIL to clear the display. Press FUNC to
advance to the next function.