DIGITIZE DGM-32/64, Руководство по установке и обслуживанию

Страница: 34 / 59

DGM INSTALLATION AND MAINTENANCE MANUAL
24 700135-0000 Rev. O
To view or change the First Zone Number, press “1”, FUNC or, if you are viewing the
previous function, just press FUNC. The second line of the display will read
“1 - 1st
Zone Num.” A message will scroll on the first line:
The Number assigned to the first zone in this DGM panel is 0001.
Default is 0001. Press CLR/SIL to clear display or FUNC to view next
Function.
To change the starting zone number, enter the new number on the keypad and
press ENTER. The new starting zone number will display in the scrolling message.
As with Function 0, if the number entered was out of the range, a message will
display to indicate that the value was not valid, and the original First Zone number
will display. Press CLR/SIL to clear the display. Press FUNC to advance to the next
function.
4.3.3 FUNCTION 2 (SETTING THE TIME )
Note: This function is automatically downloaded from the SYSTEM 3505 PRISM LX
in the following instances:
•
The SET button is pressed in the SET TIME mode.
•
Once a day automatically.
•
Whenever the SYSTEM 3505 PRISM LX is restarted.
The current time is downloaded each time the SYSTEM 3505 PRISM LX is powered
up. The time is also downloaded to the DGM panel any time its link is been restored
from a data link down condition. Presently, the DGM does not need a time reference
for any operational feature, and it will operate properly even if the time is incorrect.
To view or change the Time, press “2”, FUNC or, if you are viewing the previous
function, just p
ress FUNC. The second line of the display will read “2 - Set Time
Day.” A message will scroll on the first line:
Not used. Press CLR/SIL to clear display or FUNC to view next Function
.
Time in the DGM is displayed by six digits that represent 24 hour military time (ex.:
1:00PM = 130000). To change the Time, enter the new time on the keypad and
press ENTER. The new time will display in the scrolling message. If the number
entered was out of the range, a message will display to indicate that the value was
not valid, and the original Time will display. Press CLR/SIL to clear the display.
Press FUNC to advance to the next function.
4.3.4 FUNCTION 3 (SETTING PASSNUMBER)
The Passnumber allows access to the programming area of the DGM. Passnumbers
are comprised of any 6-digit number, which may be changed by the user.
To view or change the Passnumber, press “3”, FUNC or, if you are viewing the
previous function, just press F
UNC. The second line of the display will read “3 - Set
Passnumber.” A message will scroll on the first line:
The Passnumber is 123456. Change by entering the new 6 digit
Passnumber, then press ENTER. Press CLR/SIL to clear display or
FUNC to view next Function.