DIGITIZE DGM-32/64, Руководство по установке и обслуживанию

Страница: 32 / 59

DGM INSTALLATION AND MAINTENANCE MANUAL
22 700135-0000 Rev. O
STEP 3: If the password was entered correctly, "ACCESS GRANTED" will appear on the
display. Access to the programming area will be provided for 5 minutes. If the password
was entered incorrectly,
“ENTER PASSNUMBER” will display.
4.3 PROGRAMMABLE FUNCTIONS
The following programmable functions are available on the DGM. This section
explains how to set them.
FUNCTION 0
FUNCTION 1
FUNCTION 2
FUNCTION 3
FUNCTION 4
FUNCTION 5
FUNCTION 6
FUNCTION 7
FUNCTION 8
FUNCTION 9
FUNCTION 10
FUNCTION 11
FUNCTION 12
FUNCTION 13
FUNCTION 14
FUNCTION 15
FUNCTION 16
FUNCTION 17
FUNCTION 18
FUNCTION 19
FUNCTION 20
FUNCTION 21
FUNCTION 22
FUNCTION 23
FUNCTION 24
FUNCTION 25
FUNCTION 26
FUNCTION 27
FUNCTION 28
FUNCTION 29
FUNCTION 30
FUNCTION 31
FUNCTION 32
FUNCTION 33
FUNCTION 34
FUNCTION 35
FUNCTION 36
FUNCTION 37
Setting DGM Panel Number
Setting First Zone Number
Setting the Time
Setting the Passnumber
Setting Beep on Alarm
Setting Data Synchronization
Setting Tamper/ Tilt Sensitivity
Clock Status
Setting Telegraph Speed
Setting Telegraph On/Off Ratio
Setting Baud Rate
Setting Request to Send Timing
Setting Zone Delays on Report
Setting Zones to Bypass During Day Mode
Setting Communication Format
Setting Global Command Response
Setting Day Mode/ Burglary Panel Operation
Setting Open/Closed Telegraph Index
Resetting Panel to Factory Defaults
Setting Trouble Relay 0 (K1) on Trouble
Setting Trouble Relay 0 (K1) on Alarm
Setting the Call Out Option
Setting Zone to Normally Open/Closed
Setting PIN Numbers
Setting the Store Events Option
Backporch Timing
AC Power Fail Delay Timing
Setting Pin Number Length
Activate Keypad
Assign Additional Zones to Follow Keypad
Link Down Delay Time
Stack Link Delay
Selecting the Keypad
Toggle Relays On/Off
Display Bypass Zones
Display Keypad Status
Disable Led
Forced Parity