background image

A.  To bypass effects, press the active 1-5 footswitch. The display will read “BYPASS”. 
B.  To exit Bypass mode, press the active 1-5 footswitch again.
C.  To use the Tuner, press and hold the active 1-5 footswitch for 2 seconds. The display will 

briefly read “TUNER” then enter Tuner mode.

D.  Play a note on 

the guitar. The 
note will be 
shown in the 
display and 
arrows in the 
display will 
indicate if the 
note is sharp, 
flat, or in tune.

E.  To exit Tuner 

mode, press 
any of the 1-10 
footswitches.

MAKING CONNECTIONS / APPLYING POWER

BYPASSING EFFECTS & USING THE TUNER

WHAT’S IN THE BOX

• 

RP1000 Multi-Effects Switching System & USB Recording Interface

• 

Power Supply

REGISTER YOUR PRODUCT

To activate your warranty, please register at  
http://digitech.com/en-US/support/warranty_registration.

GET X-EDIT

To get the X-Edit software, visit  
http://digitech.com/en-US/products/RP1000#downloads.

GET THE OWNER’S MANUAL

Scan the QR code to get the owner’s manual or visit  
http://digitech.com/en-US/products/RP1000#documentation. 

1

2

Live Application

Recording / Practice Application

A.  Set your amp(s) to a clean tone, set the 

tone controls for a flat EQ response 
(on most amps, this would be 0 or 5 
on the tone controls), turn the volume 
control(s) all the way down, then power 
off the amp(s). If connecting to a mixer, 
fully lower the corresponding channel 
fader(s).

B.  Make connections as shown in the 

diagrams to the right, depending on 
application type.

C.  Connect the included power supply to 

the POWER input jack and plug it into 
an available AC outlet.

D.  Set the RP1000’s MASTER LEVEL 

control to 30.

E.  Power on your amp(s). slowly raise the 

amp volume control(s) for the desired 
volume. If using a mixer, adjust each 
channel’s gain/trim and fader controls 
for the desired volume.

Press for Bypass, hold for Tuner

E

Sharp

In Tune

Flat

Отзывы: