Default Login Information
Username:
admin
Password:
admin
Quick Start Guide
Quick Start Guide
WHAT’S IN THE BOX
QSG Manual
1 Set
Tapping
Screws PA
3x25 – 3pcs
1 Set
Mounting
Template
1 Set
Plastic Plugs
– 3pcs
1 Set
Waterproof
Cap
1 Set
Machine
Screw PWM
3x5 – 1pc
1 Set
Rubber Plug
1 Set
1.
The mounting surface must bear three times the weight of your camera.
2.
Do not let the cables get caught in improper places or the electric line cover
to be damaged. This may cause a breakdown or fire.
3.
Using the mounting template sheet or the camera itself, mark and drill the
necessary holes in the wall or ceiling.
5.
To use the camera’s water proof wiring:
(1).
Install the LAN cable into .
(2).
will be assembled to with a 1/4 turn.
(3).
Thread tightly to .
6.
Mount the rubber plug to the gap of the mounting base. Then secure the
mounting base with camera to the wall with screws.
7.
Adjust the camera to obtain an optimum angle by using the camera’s
bracket. The camera’s max angles are:
Pan:
0°~ 360°
Tilt:
0°~ 90°
When the proper view has been achieved, tighten the fixed screws to finish
the installation.
8.
Remove the protection film softly to finish the installation.
4.
Pass the wires through the mount bracket and make all necessary
connections.
a.
NETWORK CONNECTIONS – If you are using a PoE Switch, connect the
camera using an Ethernet cable for both data and power.
b.
NETWORK CONNECTIONS – If you are using a non-PoE switch, connect
the camera to the switch using an Ethernet cable for data transmission
and use a power adapter to power the camera.
STEP 1 – PREPARING TO MOUNT THE CAMERA
STEP 3 – INSTALLING THE CAMERA
STEP 2 – CABLING THE CAMERA TO EXTERNAL DEVICES
a
a
b
b
c
NOTE:
To ensure moisture seal, make sure the o-ring is in place between
and . In extreme environments use of an outdoor rated
sealer is recommended.
a
b
NOTE:
When using the waterproof cap, crimp the RJ45 connector after
passing the cable through the waterproof cap.
Power Requirements
Power Consumption
DC 12V
POE IEEE 802.3af
LED On: 6.5W
LED Off: 2.5W
NOTE:
Download All Your Support Materials and Tools in One Place
1. Go to:
http://www.digital-watchdog.com/support-download/
2. Search your product by entering the part number in the ‘
Search by Product
’ search
bar. Results for applicable part numbers will populate automatically based on the
part number you enter.
3. Click ‘
Search
’. All supported materials, including manuals, Quick Start Guides
(QSG), software and firmware will appear in the results.
Tel: +1 (866) 446-3595 / (813) 888-9555
Technical Support Hours:
9:00AM – 8:00PM EST, Monday thru Friday
digital-watchdog.com
Attention: This document is intended to serve as a quick reference for initial
set-up. It is recommended that the user read the entire instruction manual for
complete and proper installation and usage.
DWC-MBT4Wi28
DWC-MBT4Wi36
Power
Ethernet
Cable
Ethernet
Cable
4 a
4 b
5
a
b
c
Template
Sheet
Rubber
Plug
1
2
6
3
7
Tilt: 0° ~ 90°
Rotation: 0° ~ 360°
