Digital Projection E-Vision Laser 5100 Series
Basic Operating Instructions
Switching the projector on
1. Connect the power cable between the mains supply and the projector.
The
POWER
indicator lights green to indicate that the projector is in STANDBY mode.
2. Press one of the following buttons:
l
On the remote control, the
ON
button
l
On the projector control panel, the
POWER
button.
The
POWER
indicator begins flashing green. In approximately 20 seconds, the startup screen
appears. The projector is now switched on.
The first time you use the projector, you can set OSD language from the quick menu.
(See Setting the OSD language in the user manual.)
Switching the projector off
1. Press
OFF
on the remote control or
POWER
on the control panel, then press again to
confirm your choice.
The
POWER
indicator on the control panel will start flashing green, the light source will
go out and the cooling fans will run for a short time. The
POWER
indicator stops flashing
green and changes to solid green when the projector enters Standby mode.
2. If you need to switch the projector off completely, wait until the projector enters Standby
mode, then disconnect the AC power cable from the projector.
Selecting an input signal
1. Connect one or more image sources to the projector.
2. Select the input you want to display:
l
Press one of the input buttons or the source button on the remote control.
l
Press
MENU
on the remote control or control panel and navigate to the Source
setting in the Settings 1 tab, or press
SOURCE
on the control panel. Use the
UP
and
DOWN
navigation buttons to select the input source in the
SOURCE
menu.
Press
ENTER
to confirm your choice.
Rev B September 2020
page 24
Important Information
