Compliance with International Standards
Digital Projection E-Vision Laser 5100 Series
Compliance with International Standards
RF Interference
FCC
The Federal Communications Commission does not allow any modifications or changes to the
unit EXCEPT those specified by Digital Projection in this manual. Failure to comply with this
government regulation could void your right to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant with Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area may
cause harmful interference, in which case the user will be responsible for correcting any
interference.
Noise
GSGV Acoustic Noise Information Ordinance
The sound pressure level is less than 39 dB (A) according to ISO 3744 or ISO 7779.
European Waste Electrical and Electronic Equipment (WEEE) Directive
Digital Projection Ltd is fully committed to minimising Waste Electrical and Electronic
Equipment. Our products are designed with reuse, recycling and recovery of all
components in mind. To this end, at end of life, your projector may be returned to
Digital Projection Ltd or its agent so that the environmental impact can be minimised.
Important Information
Rev B September 2020
page 21
