XTLplus Series Installation and Programming Guide | Digital Monitoring Products
18
Once the SSID is entered, press
CMD
and SEARCHING displays.
When an SSID is entered for the first time or changed, the panel searches for the SSID
entered to ensure communication. The keypad displays SSID FOUND or SSID NOT
FOUND. When the SSID is found, the security type is also detected.
Depending on the security type, the SSID might take several seconds to process. If
the panel can not connect to the desired network SSID NOT FOUND displays. Press
CMD
and WPS LIST MANUAL displays. Press
CMD
again to display TEST.
Test
Press the first Select Key or Area to select TEST and the panel will attempt to verify
connection of your system to the correct Wi-Fi network. This option allows for testing
communication outside of the system's initial set up.
Wireless Security Type
When successful, W/L SECURITY displays. Select the security type based on the
network router programming. The default network security type is WPA-PSK. Press
any Select Key or Area to display the other security options. The available options are
WEP, WPA, and NONE.
▶
Press the first Select Key or Area to choose
WEP
▶
Press the second Select Key or Area for
WPA
▶
Press the third Select Key or Area for
NONE
If the panel is unable to detect the security type, W/L SECURITY with the default
security type WPA-PSK displays. If a different security type is required, press
CMD
and WEP WPA NONE displays. Press the Select Key or Area of the desired security
type to choose.
When connecting to the Wi-Fi network the panel also detects the security type in use
and W/L KEY: *************** displays.
Enter the W/L KEY and the panel performs a connection test and CONNECTING
displays. When successful, CONNECTED displays on the keypad. If the panel does not
connect to the Wi-Fi network, NOT CONNECTED displays. Press
CMD
to return to the
WIFI SETUP main screen.
Wireless Network Key
This option displays only if
COMM TYPE
is set to Wi-Fi and Security option is not
set to NONE. Enter the key provided from the network router’s programming. WEP
requires a network password of 10 characters (WEP64) or 26 characters (WEP128),
using a combination of the number 0-9 and the letters A-F. WPA/WPA-PSK uses
a custom key that allows 8 to 32 characters (See the table
to enter lowercase or special characters). Press
CMD
to save the
key.
Note:
Depending on the security type, the key might take several seconds to
process.
DHCP
If the panel uses a dynamic IP address, select
YES
. When set to
YES
the panel
operates in DHCP and will not use the Local IP Address number. Default is
YES
.
Local IP Address
Enter the local IP address for the panel. The Local IP Address must be unique and
cannot be duplicated on the network. The default local IP address is
192.168.000.250
.
Gateway Address
Enter the local gateway address. The Gateway IP Address is needed to exit the local
network. The default gateway address is
192.168.000.001
.
WIFI SETUP
ENTER SSID
SSID:
SSID FOUND
SSID:
SSID NOT FOUND
W/L SECURITY:
WPA-PSK
W/L SECURITY:
WEP WPA NONE
W/L SECURITY:
WPA-PSK
W/L SECURITY:
WEP WPA NONE
W/L KEY:
*****************
W/L KEY:
-
W/L KEY:
*****************
DHCP
NO
YES
LOCAL IP ADDR
192.168.000.250
GATEWAY ADDR
192.168.000.001