BBD43 (UL)
INSTALLATION INSTRUCTIONS
This product must be installed in accordance with
applicable installation codes by a person familiar
with the construction and operation of the product
and the hazards involved.
To avoid risk of electrical shock, disconnect light
luminaire power before connecting BBD43 unit
before installing,wiring, or servicing hardware.
If you attach a safety cable, attach it to the
luminaire in accordance with all national, state,
and local construction codes.
Do not use luminaire or BBD43 if the housing,
suspension cables, optics, or power cables
are damaged.
Do not touch or scratch the luminaire optics, as
you may damage the optical coating. To clean the
module, use a damp cloth and gently swab the
affected area.
Handle luminaire only by the end caps. Do not
grasp or handle luminaire by the light bars or
BBD43 unit housing.
The light source contained in the luminaire shall
only be replaced by the manufacturer, his service
agent, or another qualified person.
The battery is non-replaceable.
Replace BBD43 unit when luminaire no longer
runs for required backup time. Follow
disconnect instructions and contact a Digital
Lumens representative.
Note the maximum mounting height for DLE
luminaires with BBD43
:
—
DLE-12/18/24 — 58 ft (17.7 m)
—
DLE-48 — 77 ft (23.5 m)
Do not use outdoors.
Do not mount near gas or electric heaters.
Use caution when servicing batteries. Battery acid
can cause burns to skin and eyes. If acid is spilled
on skin or eyes, flush acid with fresh water and
contact a physician immediately.
Equipment should be mounted in locations and at
heights where it will not be subjected to tampering
by unauthorized personnel.
The use of accessory equipment not
recommended by manufacturer may cause an
unsafe condition.
Do not use this equipment for other than its
intended use.
READ THESE INSTRUCTIONS BEFORE USING THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
PRODUCT SAFETY
When using electrical equipment, basic safety precautions should always be followed, including the following: