Digital Juice EVO PRO Fluid Head, Руководство пользователя

Страница: 9 / 16

7
USER’S GUIDE
Setup & Use
of the EVO PRO
Tripod System
(continued)
NOTE:
To determine center of
mass, you can balance
the camera on a pencil
or pen to find the point
where it comes closest
to balancing.
NOTE:
The quick-release plate
is intentionally designed
so that the plate will not
slide off in the forward
direction as a safety
precaution.
Attaching your camera to the EVO PRO fluid head
1. Remove the quick-release plate from the EVO PRO by
loosening the lever on the right side (39). Then, depress
the silver release button on the opposite side and slide
the plate backwards towards the handle and off the top
of the fluid head
(40) .
37 38
39
40
4. Pan bar handle mounting rosettes are located on both the
left and right sides at the rear of the fluid head. If not already
attached, secure the pan bar handle to either side’s rosette
handle mount. Adjust the angle of the handle by loosening the
attachment lever lock
(37) and resetting the handle’s rosette
position. When desired angle is achieved, tighten lever lock
again securely. Handle length can also be adjusted by releasing
the lever lock in the middle of pan bar to extend the telescoping
handle to the desired length
(38) .
2. Attach the quick release plate to your camera using the supplied
mounting screws. Both 1/4”-20 and 3/8”-16 mounting screws
are provided. Place the center of the plate as close as possible
to the camera’s center of mass.