Digital Equipment RapidPrint 500, Справочное руководство, Страница: 32 / 192

Maintenance Issues Getting Started
3 - 4
3.1.2.3.3 Clear and Purge
Clear Removes an item immediately, but does not make a permanent change.
When the unit is rebooted, the old setting will again be in effect.
Purge Removes an item permanently, but generally does not take effect until the
unit is rebooted. Purge Port will take effect as soon as the port is logged
out.
3.1.2.4 Abbreviating Keywords
On the command line, it is only necessary to type as many characters as are needed to distinguish
the keywords from one another. For example, the following two commands are equivalent:
Figure 3-2: Full and Abbreviated Commands
Extra white space (more than one consecutive space between keywords) is ignored.
3.2 Maintenance Issues
The following sections detail configuration that is required on a sporadic or ongoing basis.
3.2.1 Changing the Server Name
The RapidPrint 500 is initially configured with a server name. However, you can give the server a
custom name of up to 13 alphanumeric characters using the following command:
Figure 3-3: Changing the Server Name
The server name string must be enclosed in quotes if lowercase letters are used.
3.2.2 Rebooting the RapidPrint 500
There are two ways to reboot the RapidPrint 500: pressing the Reset button while using EZCon, or
entering the Initialize command at the Local> prompt.
Options to the Initialize command include rebooting the server, reloading the Flash-ROM code,
and restoring the unit’s factory default settings. The example below shows a simple (and immedi-
ate) reboot.
Figure 3-4: Rebooting the RapidPrint 500
NOTE: See Initialize Server for a complete description of the command.
Remember that any settings that were set but not defined or saved (such as port and server set-
tings) will be lost when rebooting.
Local>> DEFINE PORT BITRONICS ENABLED DSRLOGOUT ENABLED GROUPS 1-5,77,123-139
Local>> DEF PO BI EN DSR EN GR 1-5,77,123-139
Local>> DEFINE SERVER NAME “PrintServer”
Local>> INITIALIZE SERVER DELAY 0