Digital Equipment RapidPrint 500, Справочное руководство

Страница: 173 / 192

11 - 55
11.104 Test Loop
Tests the network connections to MOP hosts. A simple loopback service verifies that the remote
node is receiving the server’s transmissions. An Assistant or “helper” node can be specified to for-
ward one or both of the transmissions (outbound or incoming).
Restrictions You must be the privileged user to use this command.
Parameters address
Specify either a text host name or an Ethernet address. Ethernet addresses
are specified in xx-xx-xx-xx-xx-xx (hexadecimal) format, where each xx
represents one of the 6 bytes of the node’s hardware address. If text
names are used, only LAT service names can be resolved to hardware
addresses.
Examples
Local> TEST LOOP 45-a2-ed-48-12-3c
Local> TEST LOOP 12-68-df-ea-38-c5 HELP REC ASSI 78-23-ad-
2c-11-4e
Local> TEST LOOP LABVAX
11.105 Test Port
Tests a port’s connection by sending a continuous stream of ASCII alphabetic characters from the
port for a certain number of lines. If no width or count is specified, the server will produce 70-
character lines until a key is pressed to stop the test.
Restrictions You must be the privileged user to test a port other than your own. Vir-
tual and multisession-enabled ports can only be tested by the current user
on that port.
Parameters PostScript
Sends a PostScript test page to the port instead of ASCII data. The Count
parameter controls the number of pages to print in this case, and the
Width parameter is ignored.
Examples
Local> TEST Port
TEST LOOP address HELP
RECEIVE
TRANSMIT
FULL
 
 
 
 
 
ASSISTANT address
TEST PORT POSTSCRIPT
[ ]