Digital Equipment Pro-Face PL-6700 43 Series, Руководство пользователя

Страница: 65 / 97

Chapter 5 - System Setup
PL-6700 43 Series User’s Manual 5-12
IDE HDD Block Mode
Designates the Hard disk's Block Operation Mode. The two selections
available are [Disabled] or [Enabled]. The [Enabled] selection is factory
set and recommended for most users.
Onboard FDC Controller
Designates whether the PL's FDD(Floppy Disk Drive) controller is used or
not. The two selections available are [Disabled] or [Enabled]. The [Enabled]
selection is factory set and recommended for most users.
Onboard Serial Port1
Designates the PL's Serial 1(COM1) port address setting. The selections
include [Disabled], [2F8/IRQ3] or [3F8/IRQ4]. The [3F8/IRQ4] selection is
factory set and recommended for most users.
Onboard Serial Port2
Designates the PL's Serial 1(COM1) port address setting. The selections
include [Disabled], [2F8/IRQ3] or [3F8/IRQ4]. The [2F8/IRQ3] selection is
factory set and recommended for most users.
UART2 Mode
Only when the Onboard Serial Port2 is set to [Disabled] can the UART2
Mode be used. The selections include [Normal], [Sharp IR], [IrDA SIR],
[IrDA MIR]or[IrDA FIR].The [Normal] selection is factory set and
recommended for most users.
Onboard Parallel Port
Selects the PL's Parallel Port Address. Normally, use [3BC/IRQ7]. The
selections include [Disabled], [3BC/IRQ7], [378/IRQ7] or [278/IRQ5].
When any selection other than [Disabled] is used, [EPP], [ECP],
[Compatible] or [Extended] must also be selected. Also, if [EPP] has been
selected, either Ver [1.7]or Ver [1.9] must be selected. Last, if [ECP] has
been selected, either ECP Mode use DMA's [1] or [3] must also be selected.
Parallel Port Mode
Here, the parallel port's single-direction ([Normal]) or dual-direction ([EPP],
[ECP] or [ECP
→
EPP]) modes can be selected. The selections include
[Compatible], [Extended] or [ECP]. Normally, [Compatible] is used,
however when a selection other than [Compatible] is used, the [ECP mode
Use DMA] selection must also be used.
ECP Mode Use DMA
Designates which DMA setting is used for the ECP mode. The two
selections available are [1] or [3]. The [1] selection is factory set and
recommended for most users.
Com 3 & Com 4 Mode
Designates whether the PL's COM3 and COM4 (Touch Panel) are used or
not. The two selections available are [Disabled] or [Enabled].
Com 3 Port Resource
Only when the "Com 3 & Com 4 Mode" is set to [Enabled] will this
selection appear. The [3E8/IRQ11] selection is factory set and
recommended for users.
Com 4 Port Resource
Only when the Com 3 & Com 4 Mode is set to [Enabled] will this
selection appear. The [2E8/IRQ10] selection is factory set and
recommended for most users.
5-2 System Parameters