Digital Ally, Inc.
|
DVM Operation
4-7
DVM-800 Operation Guide
|
860-00186-00 Rev L
4.9 Video Playback
The most recent video recording can be played back by
pressing the
Play/Pause
button
while in Standby.
Other videos can be viewed by using the Playback List. The
playback list menu is only accessible when videos are present
on the DVM Playback List:
•
To display the Playback List from Standby;
momentarily press and release the
or
button.
• When the list appears, use the
or
button to highlight the desired
event and press the
Play/Pause
button
to begin playback.
• Return to the playback list during playback by pressing the
button.
• Playback list information:
◦
The DVM-800 can record two channels simultaneously. In the CH
column, “1” is the front channel and “2” is the rear channel.
◦
DATE = 8-characters in length, representing the date of the event
(yyyymmdd).
◦
TIME = 6-characters in length, representing the time of the event
in a 24hr format (hhmmss).
◦
INCIDENT ID = Up to the first 15-characters of the Incident ID can
be displayed; the actual number of the Incident ID is variable per
event. Nothing will be displayed if no Incident ID is assigned to
the event by the user. If the Incident ID is less than 16 characters
the entire Incident ID can be displayed.
• Press and release the
button to exit the playback list.
Playback Control
• During playback, audio is played through the built in speaker and
volume is adjusted by pressing the
or
button.
• Pressing the
button increases the speed of forward playback and
the
button will reverse playback of the video. Pressing either of
these multiple times increases the playback speed.
• To pause a video during playback by pressing the
button once. To
resume playback press the button again.
• While a recording is paused, you may add a mark by pressing the Mark
Button momentarily.
• To skip to the next mark in the recording press the Mark button .
• During playback on the DVM, the L & R audio channels will be mixed by
software when output to the DVM external speaker.
4.10 Covert Operation
To enter or exit COVERT operation the unit must be either in the STANDBY or RECORD
mode. To place the unit in covert mode, press and hold the
button for 3 seconds.
This will turn the LCD display and status indicators off. To exit covert mode, press the
button again for 3 seconds. While in COVERT mode, the menu and playback screens
cannot be activated or navigated.
The Infrared LED’s will continue to function when the DVM is in covert mode. For
example, when in COVERT mode, the IR LEDs will turn ON if there is insufficient light. If
there is sufficient light the IR LEDs will turn OFF.
