Digisol DG-GS4826S, Руководство по управлению

Страница: 1095 / 1344

C
HAPTER
45 | DHCP Commands
DHCP Server
– 1095 –
ip dhcp excluded-
address
This command specifies IP addresses that the DHCP server should not
assign to DHCP clients. Use the no form to remove the excluded IP
addresses.
S
YNTAX
[ no ] ip dhcp excluded-address low-address [ high-address ]
low-address - An excluded IP address, or the first IP address in an
excluded address range.
high-address - The last IP address in an excluded address range.
D
EFAULT
S
ETTING
All IP pool addresses may be assigned.
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
Console(config)#ip dhcp excluded-address 10.1.0.19
Console(config)#
ip dhcp pool
This command configures a DHCP address pool and enter DHCP Pool
Configuration mode. Use the no form to remove the address pool.
S
YNTAX
[ no ] ip dhcp pool name
name - A string or integer. (Range: 1-8 characters)
D
EFAULT
S
ETTING
DHCP address pools are not configured.
C
OMMAND
M
ODE
Global Configuration
U
SAGE
G
UIDELINES
u
After executing this command, the switch changes to DHCP Pool
Configuration mode, identified by the (config-dhcp)# prompt.
u
From this mode, first configure address pools for the network interfaces
(using the network command). You can also manually bind an address
to a specific client (with the host command) if required. You can
configure up to 8 network address pools, and up to 32 manually bound
host address pools (i.e., listing one host address per pool). However,
note that any address specified in a host command must fall within the
range of a configured network address pool.