Digisol DG-FS4526E, Руководство по управлению

Страница: 883 / 1162

C
HAPTER
34 | ERPS Commands
– 883 –
C
OMMAND
M
ODE
ERPS Configuration
C
OMMAND
U
SAGE
If the switch goes into ring protection state due to a signal failure, after the
failure condition is cleared, the RPL owner will start the wait-to-restore
timer and wait until it expires to verify that the ring has stabilized before
blocking the RPL and returning to the Idle (normal operating) state.
E
XAMPLE
Console(config-erps)#wtr-timer 10
Console(config-erps)#
show erps
This command displays status information for all configured rings, or for a
specified ring
S
YNTAX
show erps [ domain ring-name ]
ring-name - Name of a specific ERPS ring. (Range: 1-32 characters)
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
This example displays a summary of all the ERPS rings configured on the
switch.
Console#show erps
ERPS Status : Enabled
Number of ERPS Domains : 1
Domain State MEL Enabled West East RPL Owner Ctrl VLAN
------------ ---------- --- ------- -------- -------- --------- ---------
rd1 Idle 0 Yes Eth 1/12 Eth 1/10 Yes 100
rd2 Protection 0 Yes Eth 1/3 Eth 1/4 No 200
Console#
Table 111: show erps - summary display description
Field Description
ERPS Status Shows whether ERPS is enabled on the switch.
Number of ERPS Domains Shows the number of ERPS rings configured on the switch.
Domain Displays the name of each ring followed by a brief list of status
information