Digisol DG-FS4526E, Руководство по управлению

Страница: 832 / 1162

C
HAPTER
31 | Automatic Traffic Control Commands
– 832 –
auto-traffic-control
action
This command sets the control action to limit ingress traffic or shut down
the offending port. Use the no form to restore the default setting.
S
YNTAX
auto-traffic-control { broadcast | multicast }
action { rate-control | shutdown }
no auto-traffic-control { broadcast | multicast } action
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
rate-control - If a control response is triggered, the rate of ingress
traffic is limited based on the threshold configured by the auto-
traffic-control alarm-clear-threshold command.
shutdown - If a control response is triggered, the port is
administratively disabled. A port disabled by automatic traffic
control can only be manually re-enabled.
D
EFAULT
S
ETTING
rate-control
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
When the upper threshold is exceeded and the apply timer expires, a
control response will be triggered based on this command.
When the control response is set to rate limiting by this command, the
rate limits are determined by the auto-traffic-control alarm-clear-
threshold command.
If the control response is to limit the rate of ingress traffic, it can be
automatically terminated once the traffic rate has fallen beneath the
lower threshold and the release timer has expired.
If a port has been shut down by a control response, it will not be re-
enabled by automatic traffic control. It can only be manually re-enabled
using the auto-traffic-control control-release command.
E
XAMPLE
This example sets the control response for broadcast traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast action shutdown
Console(config-if)#