Digisol DG-FS4526E, Руководство по управлению

Страница: 118 / 1162

C
HAPTER
4 | Basic Management Tasks
Setting the System Clock
– 118 –
S
ETTING THE
T
IME
Z
ONE
Use the System > Time (Configure Time Server) page to set the time zone.
SNTP uses Coordinated Universal Time (or UTC, formerly Greenwich Mean
Time, or GMT) based on the time at the Earth’s prime meridian, zero
degrees longitude, which passes through Greenwich, England. To display a
time corresponding to your local time, you must indicate the number of
hours and minutes your time zone is east (before) or west (after) of UTC.
You can choose one of the 80 predefined time zone definitions, or you can
manually configure the parameters for your local time zone.
CLI R
EFERENCES
"clock timezone" on page 622
P
ARAMETERS
The following parameters are displayed:
Direction : Configures the time zone to be before (east of) or after
(west of) UTC.
Name – Assigns a name to the time zone. (Range: 1-29 characters)
Hours (0-13) – The number of hours before/after UTC. The maximum
value before UTC is 12. The maximum value after UTC is 13.
Minutes (0-59) – The number of minutes before/after UTC.
W
EB
I
NTERFACE
To set your local time zone:
1. Click System, then Time.
2. Select Configure Time Zone from the Action list.
3. Set the offset for your time zone relative to the UTC in hours and
minutes.
4. Click Apply.
Figure 15: Setting the Time Zone