Digisol DG-FS4526E, Руководство по управлению

Страница: 1035 / 1162

C
HAPTER
40 | CFM Commands
– 1035 –
ethernet cfm port-
enable
This command enables CFM processing on an interface. Use the no form to
disable CFM processing on an interface.
S
YNTAX
[ no ] ethernet cfm port-enable
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
An interface must be enabled before a MEP can be created with the
ethernet cfm mep command.
If a MEP has been configured on an interface with the ethernet cfm mep
command, it must first be deleted before CFM can be disabled on that
interface.
When CFM is disabled, hardware resources previously used for CFM
processing on that interface are released, and all CFM frames entering
that interface are forwarded as normal data traffic.
E
XAMPLE
This example enables CFM on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#ethernet cfm port-enable
Console(config-if)#
clear ethernet cfm
ais mpid
This command clears AIS defect information for the specified MEP.
S
YNTAX
clear ethernet cfm ais mpid mpid md domain-name ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-45
alphanumeric characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Privileged Exec