Digimerge VCD304161, Инструкция по установке и эксплуатации

Страница: 10 / 91

1
2. Explanations for each function
2.1 Front Panel
The buttons on both the front panel of the VCD and IR Remote Controller have the same functions. Each
button can activate different functions. The main functions of each button are shown below.
No. Buttons Functions
1 CD-RW Backup the recording image by internal CD-RW. (Option)
2 Network LED LED is lit while the network client(s) (RemoteAgent) is connected to the system.
3 Alarm LED LED is lit when the sensor signal is inputted to the connected system.
4 HDD LED
Shows if the camera image is being stored into or retrieved from the HDD (Hard
Disk Drive).
5 Power LED Shows Power On/Off status of the system (GREEN: Working, RED: Stand-by).
6 USB Port USB interface Port to connect to external storage equipment.
7
Remote Control
Receiver
Receives input signal of the Remote Controller
8 Power Button Use to turn the Power On/Off.
9 Select Channel
The channel image will change when the corresponding up, down, left and right
button is pressed. This is same as using cursor key (direction key) on the main
screen.
10 ENTER Button Use to enter detail menu, go into the next stage, select or set value.
11 RETURN Button Use to exit from the setting menu or to cancel setting value.
12 SETUP Menu to set user environment of the system.
13 Screen Mode Selection
Select the screen mode from 1, 4, 8 and PIP screen.
14 SEQ Button Automatic time sequencing for monitor images.
15 Playback / Pause Playback recorded images/pause.
16 SEARCH Search recorded images
17 Shuttle Shuttle (outer dial): Speed up the playback speed of the image (2~32X).
18 Jog Jog (inner dial): playback frame by frame.