37
Using the Main Menu
SENSOR INPUT
Configure the sensors connected to the
system. Depending on your model, you can
connect from 4 to 16 sensors.
To set sensor input:
1. Press the
buttons to select the
sensor channel. Press the
buttons
to switch between pages.
2. Press the
buttons to set the value of
the sensor input:
•
NORMAL OPEN
: The sensor is open at
normal times
•
NORMAL CLOSE
: The senor is closed at
normal times
•
NOT USED
: No sensors are connected to
the system (default for all channels)
3. Press the
button on the remote
control until you see the Save/Exit screen.
Select
SAVE ONLY
or
SAVE AND EXIT
to save your settings.
RELAY OUTPUT
Configure the relays on the system.
To set the relay output:
1. Select
RELAY SELECT
and press the
buttons to set the type of relay:
2. Select
RELAY OUTPUT TIME
and press
the
buttons to set the length of the
relay time: 1~30 seconds.
3. Press the
button on the remote
control until you see the Save/Exit screen.
Select
SAVE ONLY
or
SAVE AND EXIT
to save your settings.
NOTE:
You can set the Relay Output for
channels 1~4 by setting the relay to the
following:
•
POWER
: The relay is working when the
system is powered off
•
USER
: The user can operate the relay
manually: press the FUNCTION button
to operate Relay 4 manually.
NC— NO
: and then press the
button
NO— NC
: and then press the
button
Figure 11.3 Sensor input menu
Figure 11.4 Relay Output menu
• REC
• USER
• POWER (N.C.)
• HDD ERROR
• MOTION
• LOSS
• ALARM
• NOT USED