113
APPENDIX F: CONNECTING MOTION / ALARM
DEVICES
You can enable motion detection and alarm control from the Main Menu. You can also connect
additional motion sensor devices to the system (i.e. motion sensors, door/window sensors). Use
a motion detector or sensor to send a signal to the system to begin camera viewing and recording
on the matching camera channel (when enabled in the Menu) For example, a window sensor unit
is installed on Alarm Block port #4. When this sensor activates, the camera on CH4 will also
become active (if enabled in the Alarm menu on the system).
To connect an external alarm sensor to the system:
1. Connect the
Ground Cable
to the desired
Channel number -
port on the rear panel.
2. Connect the
Signal Cable
to the desired
Channel
port on the rear panel.
3. From the Event Menu, select
SENSOR INPUT
.
4. Press the
buttons to select
NORMAL OPEN
,
NORMAL CLOSED
, or
NOT USED
.
SENSOR
(Not Included)
DVR
1-8
*: Alarm input terminals receive
a signal from a device (i.e. Door or
Window Sensor).
Ground
*9-16 only on 16-channel model.
NO / NC
: Alarm Output
Terminals send a signal to
another device when an
alarm input is detected.