3.2
Description
A
Answer incoming data call
Cause the modem to go off hook and attempt a handshake in answer mode
A/
Repeat last command
Cause the modem to repeat the last AT command. This command is neither preceded by AT
not followed by CR
D
Dial Command
0:9
Dial number
S=n
Dial one of the four stored phone numbers (n=0-3) in the modem non volately memory (See &z Command)
L
recall the last number dialed
E
Commands Echo
E0
Commands echo disable.
E1
Commands echo enable.
Default=E1
H
DISCONNECTION
H0
Modem disconnects
H1
Modem connects to the line and remain in command mode for the time defined in S7.
I
IDENTIFICATION
I0
Maximum line speed
I1
Product type
I2
Checksum firmware
I3
Product name
I4
Firmware release
I5
Country Code active
N
AUTOMODE ENABLE
N0
Automode detection is disabled (equivalent to setting AT+MS=X,0).
N1
Automode detection is enabled (equivalent to setting AT+MS=X,1).
Default=N1
Note: see also “AUTOMODE” parameter in AT+MS command
O
RETURN ON LINE
O0
On line state when during connection the modem is in command mode.
O1
Like previous plus equalaizer retrain.
Q
QUIET RESULT CODES
Q0
Display result codes.
Q1
No result code (quiet).
Default=Q0
SNM7003.pm6
4/8/98, 14:46
2
