Requirements for Range Test
1 PKG-E (Ethernet) RF Modem
1 PKG-R (RS-232) RF Modem
1 Windows PC loaded with the following software:
X-CTU
Com Port Redirector
Accessories (Loopback adapter, CAT5 cable, 2 RPSMA antennas, 2 power supplies)
Quick Start Guide
XStream-PKG-E
™
Ethernet RF Modem
Introduction
Com Port Communications
Range Test
Optional Configurations
www.digi.com
© 2013 Digi International, Inc. All rights reserved.
90001381_A
Introduction
This Quick Start Guide provides OEMs and integrators with an introduction to some of
the RF modem's most important features. This guide provides step-by-step
instruction on how to setup a wireless link and test the modem's ability to transport
data over varying ranges and conditions.
Software Installation #1: X-CTU
Go to the X-CTU Software page at www.digi.com/xctu and launch the X-CTU
version 5.1.0.0 installer. This version is required for the XStream Ethernet
modem. Follow the prompts on the installation screens.
The X-CTU software interface is divided into the four following tabs:
•
PC Settings - Setup PC com ports to interface with the RF modem
•
Range Test - Test RF modem's range under varying conditions
•
Terminal - Read/Set RF modem parameters and monitor data communications
•
Modem Configuration - Read/Set RF modem parameters
Software Installation #2: Device Installer and Com Port Redirector
Go to the Knowledge Base page at www.digi.com/support/kbase. In the 'Keyword'
box type '2033' and press 'Search'. Click the link to the Knowledge Base article for
detailed instructions on how to install the Device Installer and Com Port Redirector.
Create a long range wireless link in minutes!