Digi XBee DigiMesh 2.4, Руководство пользователя

Страница: 85 / 157

AT commands Serial interfacing commands
XBee/XBee-PRO DigiMesh 2.4 RF Module User Guide 85
Parameter Description
0 Disabled
1 Enabled
Default
0
KY (AES Encryption Key)
Sets the 16-byte network security key value that the device uses for encryption and decryption.
This command is write-only. If you attempt to read KY , the device returns an OK status.
Set this command parameter the same on all devices in a network.
Parameter range
128-bit value
Default
N/A
Serial interfacing commands
The following AT commands are serial interfacing commands.
BD (Baud Rate)
Sets or displays the serial interface baud rate for communication between the device's serial port and
the host.
To request non-standard baud rates with values above 0x80, you can use the Serial Console toolbar in
XCTU to configure the serial connection (if the console is connected), or click the
Connect button (if
the console is not yet connected).
When you send non-standard baud rates to a device, it stores the closest interface data rate
represented by the number in the
BD register. Read the BD command by sending ATBD without a
parameter value, and the device returns the value stored in the BD register.
Parameter range
Standard baud rates: 0x0 - 0x7
Non-standard baud rates: 0x39 to 0xF4240 if the host supports it
Value Description
0x0 1,200 b/s
0x1 2,400 b/s
0x2 4,800 b/s
0x3 9,600 b/s