Digi XBee DigiMesh 2.4, Руководство пользователя

Страница: 156 / 157

Regulatory information Japan
XBee/XBee-PRO DigiMesh 2.4 RF Module User Guide 156
operation for more information.
Approved antennas
When you integrate high-gain antennas, European regulations stipulate the EIRP power maximums.
Use the following guidelines to determine which antennas to use when you design an application.
All antenna part numbers followed by an asterisk (*) are not available from Digi. Consult with an
antenna manufacturer for an equivalent option.
The following antenna types are tested and approved for use with the XBee Module:
Yagi
RF module was tested and approved with 15 dBi antenna gain with 1 dB cable-loss (EIRP Maximum of
14 dBm). Any Yagi type antenna with 14 dBi gain or less can be used with no cable-loss.
Omni-directional
RF module was tested and approved with 15 dBi antenna gain with 1 dB cable-loss (EIRP Maximum of
14 dBm). Any Omni-directional type antenna with 14 dBi gain or less can be used with no cable-loss.
Flat panel
RF module was tested and approved with 19 dBi antenna gain with 4.8 dB cable-loss (EIRP Maximum
of 14.2 dBm). Any Flat Panel type antenna with 14.2 dBi gain or less can be used with no cable-loss.
The embedded XBee-PRO was tested and approved for use with the following antennas:
Note At 10 dBm transmit power, the PL parameter value must equal 0 , or you must use the
international variant.
Dipole
2.1 dBi, omni-directional, articulated RPSMA, Digi part number A24-HABSM *.
Chip antenna
-1.5 dBi.
Attached monopole whip
1.5 dBi.
Integrated PCB antenna
-0.5 dBi
The RF modem encasement was designed to accommodate the RPSMA antenna option.
Japan
In order to use the XBee-PRO in Japan, you must order the International version. The International
XBee-PRO RF Modules are limited to a transmit power output of 10 dBm (10 mW).
Labeling requirements
A clearly visible label on the outside of the final product enclosure must display the following text: