Getting started with the XBee Smart Modem Development Kit
Send an SMS message to a phone
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
19
9. Click the
Consoles working mode
button
on the toolbar to open a serial console to the
device. For instructions on using the Console, see the
topic in the
XCTU User Guide
.
10. Click the
Open
button
to open a serial connection to the device.
11. Click in the left pane of the
Console log
, type
hello world
and press
Enter
. The XBee Smart
Modem sends the message to the destination phone number set by the
P#
command.
12. When the phone receives the text, you can see that the sender's phone number matches the
value reported by the XBee Smart Modem with the
PH
command.
13. On the phone, reply with the text
connect with confidence
and the XBee Smart Modem
outputs this reply from the UART.
Debugging
If you experience problems with the settings in this example, you can load the default settings in
XCTU:
1. On the Configuration toolbar, click the
Default
button
to load the default values
established by the firmware, and click
Yes
to confirm.
2. Factory settings are loaded but not written to the device. To write them, click the
Write
button
on the toolbar.