Digi TX54, Руководство пользователя

Страница: 96 / 1087

Interfaces Wide Area Networks (WANs)
TX54 User Guide 96
where value is one of the following:
n
main
n
aux
n
both
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Configure cellular modem APNs
The TX54 device uses a preconfigured list of Access Point Names (APNs) when attempting to connect
to a cellular carrier for the first time. After the device has successfully connected, it will remember the
correct APN. As a result, it is generally not necessary to configure APNs. However, you can configure
the system to use a specified APN.
To configure the APN:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System . Under Configuration , click Device Configuration .
The Configuration window is displayed.
3. For single-cellular models, click Network > Interfaces > WWAN or WWAN1 > APN list .
For dual-cellular variants, there are two WWANs, WWAN1 and WWAN2 , which correspond to
each cellular modem. Select the appropriate WWAN. For example, to configure the Access
Point Names (APNs) for
WWAN1 , click Network > Interfaces > WWAN1 > APN list > APN .