Digi TransPort WR11, Руководство пользователя

Страница: 137 / 866

Use the command-line interface Using the CLI parameter tables in this guide
Digi TransPort WR Routers User Guide 137
ping command: Troubleshoot connectivity problems
Use the ping command to help troubleshoot connectivity problems. The syntax of the ping
command is:
ping <ip address|FQDN> [n]
Where n (if specified) is the number of ICMP echo requests to send. If not specified, only 1 echo
request is sent.
To stop pings when
n has been set to a high value, use ping stop .
templog command: temperature monitoring
The on-board temperature sensors are sampled every 60 seconds. Any interesting changes in the
temperature are logged to a special flash file, templog.c1 . Use templog 0 status to view the last
stored record in this file.
There are two temperature sensors built in: one on the motherboard and one on the modem
module. If a temperature is reached that is outside of normal operating limits, an event will be
logged in the eventlog.txt file.
traceroute command: Troubleshoot connectivity problems
Use the traceroute command to help troubleshoot connectivity problems. The syntax of the
traceroute command is:
traceroute <ip address|FQDN>
To stop a failed trace if hosts can not be detected, use traceroute stop .
ana command: Clear the Analyser Trace
To clear the Analyser trace, the command is:
ana 0 anaclr
clear command: Clear the event log
To clear the event log, the command is:
clear_ev